Mathey-dearman MagnaCut XM Bedienungsanleitung

1 Where there’s pipe, there’s Mathey ______________Machine Model _____________________Serial# P. O. Box 472110, Tulsa, OK 74147-2110 USA Toll Free:

10 Technical Diagrams Cont…

11Section 6 MagnaCut XM and Motor Control Box Warranty 1. The Mathey Dearman, Inc. Sales Department should be contacted prior to performing any main

1214. The MagnaCut XM should not be used without a Guide Strip when working on vertical pipe. Contact the Mathey Dearman Sales Department when appli

13Step 8: Move the Master Switch (N) to the OFF position Step 9: Move the Directional Control Switch (F) to the OFF Position and the Unit Speed Co

14Step 5: Check both Socket-Head Allen Screws (C) to ensure these are loose enough for the Machine Fuel Torch to slip into the Torch Holder Warning

15Warning: The Wheel Mounting Brackets should not be removed from the machine. Removing the Wheel Mounting Brackets may affect the tracking and may c

16Step7: Back off Socket Head Set Screws (34) 1 full turn with the 3/16-inch Allen Wrench provided. Step 8: Label the wires that connect the Torc

17Removal of the Drive Motor Step 1: Disconnect the AC Power Cord (K) from the 115vac power source. Step 2: Disconnect the DC Cord with Connecto

18Section 11 – Troubleshooting SYMPTOMS POSSIBLE CAUSES CORRECTIVE ACTION Unit fails to operate. No electrical power at Power Source. Check Circui

19Drive Motor (1) overheats. Unit is carrying larger amount of weight than it is designed to carry. Replace with a 12” Machine Torch. (Weight not to

2 Section Contents Page 1. General Description 3 2. The MagnaCut XM Package 4 3. Specifications/Technical Info

20 DC Circuit of Motor Control Box is not constant. Torch improperly adjusted. to Mathey Dearman. The MagnaCut XM is moving up and down as it moves

21 SYMPTOMS POSSIBLE CAUSES CORRECTIVE ACTION Torch Bevel Angle changes as the machine moves along the pipe or plate. Ratchet Handle (M) not ti

22Section 12 – MagnaCut Motor Control Box Electrical Adjustment There is no adjustment of the new version of the Motor Control Box. If it is not know

23Section 13 – WARRANTY Mathey Dearman, Inc. and C.I.A. Mathey, Inc. Warranty and Terms and Conditions of Sale LIMITED WARRANTY Subject to the prov

3 GENERAL DESCRIPTION The MagnaCut XM Pipe and Plate Cutting/Beveling Machine will attach to any magnetic-receptive surface using p

4Section 2 - The MagnaCut XM Package MagnaCut XM Unit and Motor Control Box Model Part Number Estimated Shipping Weight (lbs. / kg) MagnaCut

5 Section 3 – Technical Diagrams Cont… Description MagnaCut Method of Attachment to Pipe or Plate Rare Earth Magnets Magnetic Pull per Wheel Asse

6Section 4 - Technical Diagrams

7 Technical Diagrams Cont…

8 Item Part # Qty Description1 05-0550-015 1 Drive Motor, 110 Volts DC, 7,500 RPM 2 14-065M-034 4 Round Head Machine Screw, 5mm x ¾” long (

9Technical Diagrams Cont… Section 5 – Parts List DETAILC